升降橫移類立體車庫 1. 本機型采用鋼絲繩與鏈條復合傳動方式，配合大功率電機，使用更加安全可靠，車臺邊梁前端設計成斜坡，無尖角，不會扎破輪胎。 2.上車臺、橫移車臺的邊梁高度一致，方便司機存取車時出入庫。 3.有安全框進行防墜落保護，結構安全可靠。 4.后懸臂式車臺板與強固斜撐組合，結構安全，出入庫采用無梁柱設計，車輛存取安全快捷。 5.模組化彈性設計，可配合現場地形，施工快速。 6.地面必須是鋼筋混凝土結構，以利于設備立柱和膨脹螺栓固定。 7.如果柱間距E可以達到需求尺寸，則橫移車位可以通過其柱間，其柱間兩側區可以作為同一組控制，以增加車位。 8.需求凈高≥3600mm此尺寸為扣除消防管、排風管等一切設施的凈空間高度。 9.設備安裝處應該提供足夠使用的電源。 1. This machine adopts the compound transmission mode of wire rope and chain, cooperates with the high-power motor, and is safer and more reliable. The front end of the side beam of the platform is designed as a slope, without sharp angle, and will not puncture the tire. 2. The side beams of the boarding platform and the transverse platform are of the same height, which makes it convenient for the driver to enter and leave the garage when accessing the car. 3. Safety frame for falling protection, safe and reliable structure. 4. The combination of rear cantilever platform plate and strong brace is safe in structure. The design of beam-less column is adopted for access and storage, and the access of vehicles is safe and fast. 5. Modular elastic design can cooperate with the site topography, and the construction is fast. 6. The ground must be reinforced concrete structure to facilitate the fixing of equipment columns and expansion bolts. 7. If the column spacing E can reach the required size, the transverse parking space can be controlled by the two sides of the column, which can be used as the same group to increase the parking space. 8. The net height of demand (> 3600mm) is the net space height of all facilities except fire hoses and exhaust ducts. 9. Equipment installation should provide adequate power supply.