帆布芯、尼龍芯膠帶的硫化膠接，是將膠帶接頭部的膠層和芯層按一定的形式和角度，剖剝成階梯，涂以膠漿使其粘合。然后在一定的壓力、溫度和時間條件下，經過硫化反應， 上覆蓋膠下覆蓋膠邊膠條邊膠條抗拉體（骨架層）把接頭部膠粘在一起，使接頭獲得最佳的粘著強度。

膠帶硫化機驅動滾筒與改向滾筒的調整是皮帶跑偏調整的重要環節。因?yàn)橐粭l膠帶硫化機至少有2到5個滾筒，所有滾筒的安裝位置必須垂直于膠帶硫化機長度方向的中心線，若偏斜過大必然發生跑偏。其調整方法是與調整托輥組類似。對于了頭部滾筒如皮帶向滾筒的右側跑偏，則是右側的軸承座應當向前移動，皮帶向了滾筒的左側跑偏，則左側的軸承座應當向前移動，相對應的也是可將左側軸承座后移或右側軸承座后移。尾部滾筒的調整方法是與頭部滾筒剛好相反。經過反復調整直到皮帶調到較理想的位置。在調整驅動或改向滾筒前最好準確安裝其位置.詳情訪問(www.wxxwks.com)

he adjustment of the driving roller and the adjusting roller of belt vulcanizing machine is an important part of belt deviation adjustment. Because there are at least 2 to 5 rollers of a belt vulcanizing machine, the installation position of all the rollers must be perpendicular to the centerline of the length of the belt vulcanizing machine. The adjusting method is similar to that of adjusting roller group. For the head drum such as belt to the right deviation of the roller bearing seat is on the right side of the belt shall move forward, to the drum of the left deviation, then the left bearing seat shall move forward, the corresponding also can be left bearing seat back or right bearing seat back. The tail roller adjustment method is the same with the head drum. After repeated adjustment until the belt to a better position. It is best to install the position accurately before driving or changing the cylinder