6kV~35kV 中低壓銅芯及鋁芯交聯聚乙烯絕緣電力電纜（YJV電纜，YJV22電纜，YJLV電纜，YJLV22電纜）
XLPE Insulated Power Cable
交聯聚乙烯絕緣電力電纜是采用化學方法或物理方法,使聚乙烯分子由線型分子結構轉變為三維網狀結構,由熱塑性的聚乙烯變成熱固性的交聯聚乙烯,從而提高了聚乙烯的耐老化性能、機械性能和耐環境能力，并保持了優良的電氣性能。
交聯聚乙烯絕緣電力電纜導體的允許長期最高溫為90攝氏度，較低絕緣電纜、聚氯乙烯絕緣電纜和聚乙烯絕緣電纜高，且具有重量輕、結構簡單、使用方便、耐化學腐蝕和敷設不受落差限制等優點。
26/35KV電力電纜，18/30KV交聯電纜，12/20KVYJV電纜，8.7/15KVYJV22電纜線，6/10KV鋁芯交聯電纜線，3.6/6KVYJLV單芯電纜
中低壓交聯電纜產品標準 Standard
本產品按GB12706《額定電壓35V及以下銅芯、鋁芯塑料絕緣電力電纜》標準生產，同時還可根據用戶需要按國際電工委員會推薦標準IEC、英國標準、德國標準及美國標準生產。
The product is manufactured according to the standard of《GB12706 or IEC、BS、DIN and ICEA upon request.
適用范圍 Applications
本產品適用于工頻額定電壓3.6/6kv～26/35kv輸配電線路作配送電能子用。
The product is suitable for use in power transmission and distribution lines with rated power frequency voltage 3.6/6kv～26/35kv.
使用特性 Operating characteristics
· 工頻額定電壓U0/U為3.6/6kv～26/35kv。
Rated power-frepuency voltage U0/U: 3.6/6kv～26/35kv.
· 電纜導體的最高允許工作溫度：90℃。
Max.admissible operating temperature of the conductor:90℃.
· 短路時（最長時間不超過5s）電纜導體的最高溫度不超過2500C。
Max. short-circurt temperature of conductor shall not exceed 2500C.
(5s maximum duration)
· 電纜敷設時環境溫度應不低于00C。
The ambient temperature under installation should not below 00C.
· 電纜彎曲半徑：三芯電纜不小于電纜外徑15倍；單芯電纜不小于電纜外徑20倍。
The bending radius of a single-core cable should not less than 20 times of the cable diameter.
The bending radius of a single-core cable should not less than 15 times of the cable diameter.
電纜額定電壓的選擇 Voltage designation
· 電纜的額定電壓應適合于電纜系統的運行狀況，用U0/U（Um）kv表示。
U0－電纜設計用的導體對地或金屬屏蔽之間的額定工頻電壓；
U－電纜設計用的導體間的額定工頻電壓；
Um－設備可承受的"最高系統電壓"的最大值。
The rated voltage of the cable for a given applixation shall be suitable for the operating conditions
in the system in which the cable is used,and is expressed in the form of U0/U（Um）kv
Where:
U0－The rated power-frequency voltage between conductors and earth metallic screen ,for which the cable designed;
U － The rated power-frequency voltage between conductos, for which the cable designed;
Um－ The maximum value of the"highest system voltage"for which the equipment may beused.
· 三相系統用電纜的U0值推薦如下表：
The values of U0 recommened for cable to be used in three-phase systems are listed below:
|
| U kv |
U m kv |
U 0 * kv |
| A 和 B 類系統 System categories A and B |
C 類系統 Systems categories C |
| 6 |
7.2 |
3.6 |
6 |
| 10 |
12 |
6 |
8.7 |
| 15 |
17.5 |
8.7 |
12 |
| 20 |
24 |
12 |
18 |
| 30 |
36 |
18 |
－ |
| 35 |
40.5 |
21 |
26 |
|
A類系統──該類系統任何一相導體與地和接地導體接觸時，能在1min內與系統分離
B類系統──該類系統僅包括單相接地故障短時運行的條件，接地故障時間應不超過1h, 但在任何情況下，最長不超過8h每年接地故障總持續時間不超過125h；
C類系統──不屬于A類、B類的系統。
System category A──This category comprises those systems in which any phase conductor that comes in contact with earth or an earth conductor. is disconnected from the system within 1 min.
System category B ──This category comprises those system which,under faultconditions,are operated,are operated for ashorttimewith one phase earthed.This period should not exceed 1 h..Fora longer period, not exceeding 8h on any occasion, can be tolerated.The total duration of earth faults in any year should not exceed 125h.
System categeory C──This category comprises all systems which do not fall into A and B
電纜的型號Type of cable |
| 型號 Type |
名稱 Designation |
適用范圍 Application |
| YJV |
銅芯交聯聚乙烯絕緣氯乙烯護套電力電纜 Copper conductor,XLPE insulated and PVC sheathed power cable |
室內、隧道及電纜溝等場所，不能承受機械外力。單芯電纜不允許敷設在磁性管道中。 For laying indoors 、 intunnel or cable trench,unable to bear external mechan-icalforces.Single-core cable in magnetic duct is not permissible |
| YJLY |
鋁芯交聯聚乙烯絕緣乙烯護套電力電纜 Aluminium conductor, XLPE insulated and PVC sheathed power cable |
| YJY |
銅芯交聯聚乙烯絕緣氯乙烯護套電力電纜 Copper conductor ,XLPE insulated and PEsheathed power cable |
| YJLY |
鋁芯交聯聚乙烯絕緣氯乙烯護套電力電纜 Alumimium conductor ,XLPE insulated and PEsheathed power cable |
| YJV22 |
銅芯交聯聚乙烯絕緣鋼帶鎧裝聚氯乙烯護套電力電纜 Copper conductor ,XLPE insulated, steel tape armoured and PVC sheathed power cable |
室內、隧道、電纜溝內，或埋地敷設等，能承受一定機械外力，但不能承受大的拉力。 For laying indoors 、 in tunnel, cable trench, or direct in ground,able to bear external mechanicalforces, but unable to bear large pulling force 。 |
| YJLV22 |
鋁芯交聯聚乙烯絕緣鋼帶鎧裝聚氯乙烯護套電力電纜 Aluminium conductor ,XLPE insulated ,steel tape armoured and PVC sheathed power cable |
| YJV23 |
銅芯交聯聚乙烯絕緣鋼帶鎧裝聚氯乙烯護套電力電纜 Copper conductor ,XLPE insulated ,steel tape armoured and PVC sheathed power cable |
| YJLV23 |
鋁芯交聯聚乙烯絕緣鋼帶鎧裝聚氯乙烯護套電力電纜 Aluminium conductor ,XLPE insulated ,steel tape armoured and PVC sheathed power cable |
| YJV32 |
銅芯交聯聚乙烯絕緣細鋼絲鎧裝聚氯乙烯護套電力電纜 Copper conductor,XLPE insulated,steel wire armoured and PVC sheathed power cable |
室內、隧道、電纜溝、豎井或埋地敷設等，能承受機械外力和一定的拉力。 For laying indoors 、 in tunnel, cable french, well or direct in ground,able to bear external mechanical forces, and certain force 。 |
| YJLV32 |
鋁芯交聯聚乙烯絕緣細鋼絲鎧裝聚氯乙烯護套電力電纜 Aluminium conductor ,XLPE insulated, steel wire armoured and PVC sheathed power cable |
| YJV33 |
銅芯交聯聚乙烯絕緣細鋼絲鎧裝聚氯乙烯護套電力電纜 Copper conductor ,XLPE insulated ,steel wire armoured and PVC sheathed power cable |
| YJLV33 |
鋁芯交聯聚乙烯絕緣鋼帶鎧裝聚氯乙烯護套電力電纜 Aluminium conductor ,XLPE insulated ,steel wire armoured and PVC sheathed power cable |
|
| 生產范圍Production range of cable |
| 型號 Type |
芯數 Nomber of cores |
額定電壓 Rated Voltage kV |
| 3.6/6 |
6/6 6/10 |
8.7/10 8.7/15 |
12/20 |
18/20 18/30 |
21/35 |
26/35 |
| 導體標稱截面 Nominal cross-section of conductlr mm2 |
YJV
YJLV
YJY
YJLY |
1 |
25-800 |
25-800 |
25-800 |
35-800 |
50-630 |
50-630 |
50-630 |
| 3 |
25-630 |
25-630 |
25-500 |
35-500 |
50-400 |
50-400 |
50-400 |
YJV22
YJLV22
YJY23
YJLY23 |
1 |
25-800 |
25-800 |
25-800 |
35-800 |
50-630 |
50-630 |
50-630 |
| 3 |
25-630 |
25-630 |
25-500 |
35-500 |
50-400 |
50-400 |
50-400 |
YJV32
YJLV32
YJY33
YJLY33 |
1 |
25-800 |
25-800 |
25-800 |
35-800 |
50-630 |
50-630 |
50-630 |
| 3 |
25-630 |
25-630 |
25-400 |
35-400 |
50-240 |
50-185 |
50-150 |
|
